Single Collar Lock-On Grips Installation

Equipment required – Torque Wrench, 2.5mm Hex Socket Bit, Waterproof Grease.

Important - Follow all fitting instructions in order

Installation

  1. Clean handlebar surface before fitting
  2. Identify the Left and Right grips, using the L and R on the grip
  3. Slide the correct side grip onto the handlebar. Ensure the locking screw is on the underside of the handlebar
  4. As the grip reaches the end of the handlebar there will be an increase in resistance. Keep sliding the grip until it reaches a hard stop
  5. Grease under the heads and threads of the screws
  6. Tighten the screws to 3Nm maximum
  7. Re-check the torque setting after 2 hours of riding

Important Safety Information

  • This product must be fitted by a qualified mechanic
  • Do not use this product following a crash, or if the product is damaged or marked in any way
  • Never exceed 3Nm torque - This will result in stripping the threads
  • Replace the grip if it becomes damaged
  • Please retain packaging for future reference
  • Failure to comply with the warnings and installation instructions can result in complete product failure.