Integra / Integra35 Stem Fitting

Equipment required – Torque wrench, 4mm hex socket, waterproof grease.

Important - Follow all fitting instructions in order

Handlebar compatibility - The central clamping area of the handlebar must have a straight section with a minimum width of 64mm. If in doubt, consult your cycle dealer.

Installation

  1. Remove all screws from the stem and discard the plastic retention washers. Grease the threads of all screws before re-installing.
  2. Insert the shortest M6 bolts through the rear mount holes of stem body and thread into the rear mount holes of the fork top crown. Tighten until finger tight
  3. With ‘Zero Gap’ marks facing out and horizontal, place the gold clamps over the smaller, 22.2mm diameter outer section of the handlebar and slide in towards the central clamping area
  4. Insert the longest M6 bolts through the handlebar clamps, through the forward holes of the stem body and thread into the forward mount holes of the fork top crown. Tighten until finger tight
  5. Insert the M5 bolts into the handlebar clamps and tighten until finger tight
  6. Alternating between each M6 bolt, progressively tighten to a torque of 10Nm
  7. Align and rotate your handlebar into position and tighten the M5 handlebar clamp bolts to 6Nm

Maintenance

  • Before each ride, ensure all bolts are tightened to the correct torque
  • Periodically inspect all parts for signs of damage, especially in the event of a crash
  • Clean and re-grease all bolts if disassembling and re-assembling the stem

Warning

  • This product must be fitted by a qualified mechanic
  • Do not use this product following a crash, or if the product is damaged in any way