Twinwall Warnings

This product must be fitted by a qualified mechanic
Do not use this product following a crash, or if the product is damaged or marked in any way
Do not attempt to straighten bars if they become bent
In the very unlikely event that a crack appears in the outer wall of the handlebar, it is essential that the handlebar is changed. This is necessary even though the crack in the outer wall will not propagate to the inner wall
Only fit this product using a calibrated torque wrench
Do not exceed 18Nm when tightening bar mounts
Exceeding 18Nm will damage the handlebar, if you exceed 18Nm Renthal recommend you replace the handlebar
Remove any burrs from contact edge of bar mount before Installation
It is essential that 1-1/8”(28.6mm) diameter bar mounts are used
Do not damage the handlebar during installation
After installation ensure steering is not disrupted
Do not modify the handlebars
Do not mark the handlebar. Physical marking of the handlebar will lead to stress raisers which could lead to a fatigue failure
Do not drill into or modify bars and bar mounts
Do not remove or modify the rubber seals
Do not modify 7/8" clamps. It is essential that 1 1/8" mounting clamps are used
Do not power wash the rubber seals at close range
Do not clean the handlebar with any form of metal polish / concentrated cleaning fluids
Do not use the handlebar as a mounting point when transporting the motorcycle
Renthal Handlebars are warranted against defects in material and craftsmanship. Normal wear and tear is not warranted, including bending as a result of a crash
Failure to comply with the warnings and installation instructions can result in complete product failure